Jack Plates & L Brackets – Transducer Shield and Saver
4.8 (467) · $ 5.50 · In stock
L Bracket with 3 inch offset to attach a Transducer Shield to the side of an Atlas Hydraulic 8, 10 or 12 Jack Plate. Also available for the Port
ATLAS 8 to 12 Jack Plate - L Bracket # LB-AT-8.10.12-R3 (with built in offset)
Life is TOO short to Break your “Transducer” on a Relaxing Fishing Day
Choose this item for Jack Plate, Hole Shot Plate or Set Back installation to attach a Lowrance®/Simrad® Total Scan transducer # 000-12568-001 or
TS-DSS3-TS to fit Lowrance®Total Scan, Structure Scan 3D and HDS Live xDucer 2-in-1 or 3-in-1 on Jack Plate, Hole Shot or Transom Set Back
The ULTIMATE “Transducer Installation/Protection” on an Atlas jack plate with “L” Bracket & Humminbird Solix transducer! Protect
Rite Hite L Bracket without an Extender Plate is used when both pieces of the jack plate are at the same at the bottom of the jack plate., Rite Hite
Rite Hite L Bracket LB-RH-6
L Bracket to attach a Transducer Shield to the side of a CMC jack plate. It is very important that you complete the questionnaire when ordering this
LB-CMC-5/5-8 to fit 5.5 to 8 CMC Jack Plate
Jack Plates & L Brackets – Transducer Shield and Saver
Jackplate Mount Transducer Lowrance Active Imaging 3 in 1, Totalscan, LSS 2
TM-DI fits Humminbird® Down Image Transducer # XNT 9 DI T for trolling motor, set back or jack plate installation. It DOES NOT fit the redesigned Down
TM-DI fits Humminbird Down Image XNT 9 DI T xDucer for Trolling Motor, Jack Plate or Set Back
H.O.E JACKPLATE TRANSDUCER MOUNT HUM/LOW — Hennessey Outdoor Electronics
Transducer Shield & Saver Installation video BOB'S LB-BM-8/10
To fit Garmin HD ID Down Vu (8 pin) transducer number 010-12087-001 (GT20-TM)
TG-D-Vü fits Garmin DownVü GT20 xDucer for Trolling Motor, Jack Plate or Set Back
